HI 2204 Weight Transmitter

Strain Gauge Transmitter

The Hardy Instruments HI 2204LT comes sealed and potted to withstand typical industrial environments. It has a course zero offset adjustment to remove dead load, a fine zero adjustment to compensate for small differences between load cells/ points, and a span adjustment to set the operating range for the “live load.”

The transmitter produces a current limited, 5 VDC excitation voltage which powers the load cell/point momentarily at the rate of about 90 times per second and converts the signal read into a 4-20 mA output. The transmitter is used primarily in level by weight and force measurement applications.

The HI 2204LT is capable of developing its full 4-20 mA signal while requiring a "live load" of only 33% of the total load cell capacity. This is true even when four 3 mV/V, 350 ohm load cells/points are used.

The transmitter is available mounted in either an optional NEMA 4 rated painted steel  (-A2), NEMA 4X rated stainless steel (-A4) or fiberglass (-A8) box for use with a single load cell. It also is available mounted in a NEMA 4 rated painted steel (-A2), NEMA 4X rated stainless steel (-A5) or fiberglass (-A9) summing junction box for multiple load cell systems.

An optional snap track adaptor (-A1) is available for panel installations. One-foot pieces of snap track can be purchased under the HI 2291ST model number.

An intrinsic barrier assembly model HI 705IBA is available for using the HI 2204LT transmitter in a safe environment with the systems load cells in a hazardous rated environment.

(Refer to the HI 2201LT for hazardous use)